1. Each lubricating part should be filled with lubricating oil frequently. The oil should be added at least twice per shift. The press-in oiling lubrication should be filled with butter once every 20 days. The oil pool should be replaced every three months.
2. The wall plate shaft seal should be properly adjusted or replaced according to the wear and tear.
3. Check the steam pipe and each joint frequently. No leakage is allowed.
4. The machine should be inspected after six months of operation, and the vulnerable parts should be checked and repaired or replaced appropriately.
5. After the kneading machine is installed, it should be cleaned, decontaminated and wiped with anti-rust grease. Check each lubrication point and inject lubricating oil (grease).
6. Check the tension of the V-belt before driving, and move the motor to the appropriate position by adjusting the bolts.
7. Check whether the fasteners are loose, whether the steam pipe is leaking, and whether the circuit and electrical equipment are safe. The electric heating kneading machine must have a grounding device.
8. Before the test run, clean the kneading machine room and run it idle for 10-15 minutes. After confirming that the machine is running normally, put it into production. Usually, the new machine gear (including reducer) has a large noise during the initial use, which will naturally decrease after a period of running-in.
9. When using steam for heating, a safety valve and a pressure gauge should be installed at the inlet pipe, and the steam pressure should not exceed the use pressure requirement of the mixing cylinder specified on the label.
10. The kneading machine studio should minimize the use of reverse.
11. All lubricating parts should be oiled frequently.
12. There should be no leakage of raw materials from the wall panel sealing part.
13. The belt should be appropriately tight and should be checked, adjusted or replaced regularly.
14. The steam pipeline is not allowed to leak. The valve should be closed when the machine is out of use, and the reliability of the safety valve and pressure gauge should be ensured.
