The filling machine powered by compressed air constitutes a precise automatic filling system, including pneumatic components, medicine, chemical industry, food, cosmetics and other industries. The main contents of the installation and commissioning of the ideal filling equipment are as follows:
When the filling machine is out of the box, press to install. The automatic filling machine is suitable for small-dose tincture, sugaring and capping processes in pharmaceutical factories. The whole machine can complete bottle processing, bottle conveying, quantitative filling, capping, and capping. All parts in contact with medicines are made of 316L Made of stainless steel or polytetrafluoroethylene, no bottle no filling, frequency conversion speed control and other functions. Medical emulsifiers are widely used in adhesives, coatings, cosmetics, food, medicine, plastic resins, printing and dyeing, inks, asphalt and other industries. Make the material fully emulsified, delicate, evenly stirred, and remove air bubbles during the production process. Specializing in the use of cosmetic cream materials and ointment materials!
1. Loosen the nut paste filling machine, and then adjust the position of the screw fixed value change. The length of the syringe can be changed by the slider to achieve free adjustment of the distribution. Adjust the screw increment clockwise. Otherwise, reduce the pointer to indicate its purpose. Then tighten the nut under the paste machine to make the crank rod firmly fixed; then loosen the nut, After sliding the fixing rod in different lengths, loosen the nut to determine the correct position of the syringe at the lower part of the fixing rod, rotate the syringe to the top dead center inside the syringe, and then place the syringe vertically about 2mm from the outer sleeve to avoid bad ejector pins. , And then tighten the nut before starting the machine.
2. After the compressed air source is turned on, the compressed air main pipe should be pre-pressured with an air source pressure of 0.6Mpa.
3. Open the right door, turn the oil outlet, and add special cleaning oil or sewing machine oil.
4. Check whether the air source is leaking from the sealing surface, and adjust the oil inlet pressure when it is adjusted to 0.3~0.4MPa. The general operation of a drop of oil can be sprayed multiple times. Check the condition of the fuel injector regularly.
5. Loading capacity adjustment: First, turn the hand wheel to adjust the loading capacity, observe the scale of the indicator window to achieve the required loading capacity, and adjust the suction and discharge speed at the same time to achieve a satisfactory loading effect, mark the loading capacity, and correct the loading capacity.
www.mixerbeadmill.com
