How to correctly debug the horizontal sand mill

Introduction to the correct way to debug the horizontal sand mill
1. Prepare before commissioning.
2. Check the installation of all components.
3. The direction of rotation of each machine should follow the direction indicated by the arrow (please press).
4. Check whether the cooling water is smooth.
5. Adjust the V-belt to fit the restart. After 50 hours of work, it will be readjusted.
6. Add grinding media from the top of the cylinder.
7. Start the pump, enter the top screen material after discharge, and then start the host.
8. When restarting after a long shutdown, the disperser often stagnates due to the settling of solid particles and grinding media in the material, especially when the temperature of the viscous material is low. At this time, when the motor cannot be started, rotate the main shaft pulley by hand, input a small amount of solvent to dissolve the material, dissolve the material and restart. In short, in order to avoid damage to electrical appliances and the body, it cannot be forced to start.
9. When the machine is shut down for a long time, clean up the dry material.
10. Because the machine and grinding media run quickly in the cleaning fluid, they are easy to wear and damage, and the speed is fast and easy to wear and damage.
11. When new grinding is used as the medium, improved screening should be carried out to remove impurities such as information fragments.